YOKOGAWA SL1400 - Page 283

9-7
IM 701240-01E
Recording in Recorder Mode
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
ESC
When Setup of Flexible Zone is selected
Setting the Details
Setting the Print Interval of Scale Values
14. Use jog shuttle+SELECT to select the print interval of the scale.
Setting the Print Interval of Channel Label
15. Use jog shuttle+SELECT to select the print interval of the channel label (Ch
Label).
Setting the Print Interval of the Time
16. Use jog shuttle+SELECT to select print interval of the time.
Selecting the Gauge Printing
17. Use jog shuttle+SELECT to select the print interval of the gauge.
Setting the Annotation
18. Use jog shuttle+SELECT to select the print interval of the annotation.
19. Use jog shuttle+SELECT to select the type of annotation to be printed.
• If you select Ch Message, proceed to step 20.
• If you select Ch Information or Ch Data, proceed to step 21.
20. Use jog shuttle+SELECT to select Setup. Then, enter the message you want to
print using up to 80 characters according to the procedure in section 4.2. You
can enter a message for each channel.
Setting a Comment
21. Use jog shuttle+SELECT to select Comment. Then, enter the comment you
want to print using up to 20 characters according to the procedure in section 4.2.
Setting the Paper Feed after Stopping the Recording
22. Use jog shuttle+SELECT to turn After Feed ON or OFF.
ESC
When Annotation Type is set to Ch Message
and the Setup is selected
9.3 Setting the Recording Format of T-Y Waveform Recording