9-24
IM 701240-01E
9.8 Creating a PDF File of the Reprint Image
<For a description of this function, refer to page 2-40.>
Procedure
Before carrying out the procedure below, record the T-Y waveform in Chart Recorder
mode according to the procedures in sections 9.1 to 9.4 or record the X-Y waveform in
X-Y Recorder mode according to the procedures in section 9.6. This section explains the
procedure from the point when the RECORD COND menu is displayed.
1. Press the Reprint Setup soft key.
Setting the Print Destination
2. Press the Print to soft key. The print destination selection menu appears.
3. Press the PDF soft key.
For Chart Recorder mode, proceed to step 4.
For X-Y Recorder mode, proceed to step 12.
Selecting the Section to Be Output to the PDF File (Only for Chart
Recorder Mode)
4. Press the Window Mag/Window Pos soft key to select Window Mag.
5. Use jog shuttle+SELECT to set the zoom rate. You can reduce the zoom rate
to redisplay the waveform that had been cleared from the screen.
6. Press the Window Mag/Window Pos soft key to select Window Pos.
7. Use jog shuttle+SELECT to set the zoom position. You can move the zoom
position to redisplay the waveform that had been cleared from the screen.
8. Press the Start Point/End Point soft key.
9. Use jog shuttle+SELECT to set the start and end points of the section to be
output to the PDF file.
Setting the Print Magnification (Only for Chart Recorder Mode)
10. Press the Print Mag soft key.
11. Use the jog shuttle to set the magnification of the section that you selected in
steps 4 to 9 to be output to the PDF file. The top row of the menu shows the
magnification; the bottom row shows the number of pages when the waveform is
recorded using the magnification indicated in the top row.
Chart Recorder mode X-Y Recorder mode
To Next Page
Loading...
