YOKOGAWA SL1400 - Setting the Record Conditions of T-Y Waveform Recording

9-3
IM 701240-01E
Recording in Recorder Mode
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
9.2 Setting the Record Conditions of T-Y
Waveform Recording
<For a description of this function, refer to page 2-37.>
Procedure
Before carrying out the procedure below, select Chart Recorder mode according to the
procedures in section 9.1.
Selecting the Chart Speed
1. Press CHART SPEED.
2. Turn the jog shuttle to select the chart speed.
Setting the Record Conditions
1. Press MENU.
2. Press the RECORD COND soft key.
3. Press the Print Style soft key to select Wave.
Enabling/Disabling T-Y Recording to the Built-in Printer
4. Press the Printer Output soft key to select ON or OFF.
Setting the Shot Recording
5. Press the Shot Recording soft key. A menu used to select the length of the
shot recording is displayed.
6. Press the soft key corresponding to the desired length of the short recording.
Setting the Trigger Mode
1. Press MENU.
2. Press the Trigger soft key.
3. Press the Mode soft key.
4. Press the soft key corresponding to the desired mode to select the trigger mode.
For a description of other trigger condition settings, see chapter 6.