15-8
IM 701240-01E
15.3 Saving/Loading Data to a Network Drive (FTP
Client Function)
<For a description of this function, refer to page 2-47.>
Procedure
1. Press MENU.
2. Press the Next 1/2 soft key.
3. Press the Network soft key.
4. Press the Net Drive Setup soft key. The Net Drive setup menu appears.
Setting the FTP Server
5. Use jog shuttle+SELECT to select FTP Server.
6. Enter the IP address of the FTP server according to the procedure given in
section 4.2. When using DNS (section 15.2), you can specify the address by
name.
Setting the Login Name and Password
7. Use jog shuttle+SELECT to select Login Name.
8. Enter the login name using up to 15 characters according to the procedure given
in section 4.2.
9. Use jog shuttle+SELECT to select Password.
10. Enter the password corresponding to the login name using up to 15 characters
according to the procedure given in section 4.2.
Setting the Timeout Time
11. Use jog shuttle+SELECT to set Time Out. The selectable range is 0 to 3600 (s).
Note
If Login Name is set to anonymous, you do not have to enter the password.
Connecting/Disconnecting to a Network Drive
12. Use jog shuttle+SELECT to select Connect. Connection is made to the network
drive. When the connection is established, is displayed at the upper right
corner of the screen.
Use the jog shuttle to move the cursor to Disconnect, then press SELECT to
close the connection. The
displayed at the upper right corner of the screen
disappears.
To Next Page
Loading...
