10-4
IM 701240-01E
10.2 Performing Binary Computation
<For a description of this function, refer to page 2-41.>
Procedure
1. Press MENU.
2. Press the MATH soft key.
3. Press the Mode soft key to select ON.
Setting the Computation Start and End Points
4. Press the Start Point/End Point soft key to set the jog shuttle control to Start
Point.
5. Turn the jog shuttle to set the start point.
6. Likewise, set the End Point.
Setting the Computation
7. Press the Setup soft key. The Math1 to Math8 setup dialog boxes appear.
8. Use jog shuttle+SELECT to select the desired Math waveform. The
corresponding Math waveform setup dialog box appears.
Setting the Computing Operation
9. Use jog shuttle+SELECT to set Operation to Bin(S1).
Selecting the Channel on Which to Perform Computation
10. Use jog shuttle+SELECT to select Source.
Setting the Scaling
11. Use jog shuttle+SELECT to set Scale to Auto or Manual.
If you select Manual, proceed to step 12; if you select Auto, proceed to step 14.
To Next Page
Loading...
