9-21
IM 701240-01E
Recording in Recorder Mode
9
10
11
12
13
14
15
16
17
18
App
Index
Displaying the Preview (Only If Continue Is Selected in Step 5)
14. Press the Preview soft key.
15. Turn the jog shuttle to select the page you want to preview.
16. Press the Quit soft key to close the preview display.
Executing the Reprint Operation
17. Press the Print Exec soft key. Reprint is executed using the conditions set in
steps 6 to 13.
Reprinting the Waveform Recorded in X-Y Recorder Mode
Before carrying out the procedure below, record the X-Y waveform in X-Y Recorder
mode according to the procedures in sections 9.1 to 9.6. This section explains the
procedure from the point when the RECORD COND menu is displayed.
1. Press the Reprint Setup soft key.
Setting the Print Destination
2. Press the Print to soft key. The print destination selection menu appears.
3. Press the Printer soft key.
Executing the Reprint Operation
4. Press the Print Exec soft key to execute the reprint operation.
Explanation
The waveform data of the T-Y waveform recorded in Chart Recorder mode or the
measured data of the X-Y waveform recorded in X-Y Recorder mode is stored in the
internal memory.
Reprinting the Waveform Recorded in Chart Recorder Mode (T-Y Waveform
Recording)
Print to
To reprint the waveform recorded in Chart Recorder mode (T-Y waveform recording), set
the print destination to Printer (built-in printer).
9.7 Reprinting on the Built-in Printer
To Next Page
Loading...
