IM 701240-01E
5-48
Executing Balancing When Measuring Strain
2. Press the Strain Balance soft key.
3. Use jog shuttle+SELECT to select the channel on which to execute balancing.
Select a channel in which a strain module is installed.
4. Turn the jog shuttle to move the cursor to Exec and press SELECT. Balancing
is executed.
Explanation
You can display the setup menu of all the channels (excluding logic input) over the entire
screen to set the channels. The following items can be specified.
• Waveform color
• Display ON/OFF
• Measurement range
• Input coupling
• Bandwidth limit
• Probe attenuation or current-to-voltage conversion ratio
• Variable ON/OFF
• Zoom rate and vertical position (when Variable is OFF)
• Upper and lower limits of the display range (when Variable is ON)
• Linear scale
5.19 Entering Settings on the All Channel Menu
To Next Page
Loading...
