6-16
IM 701240-01E
Explanation
This is the edge trigger when the trigger source is set to a logic waveform.
Trigger Source
Select Logic A or Logic B.
Bit to Assign the Trigger Slope (Logic Bit)
Select the trigger source from Bit 1 to Bit 8.
Trigger Slope
Select how the trigger source is to cross the specified level for activating the trigger from
the following two choices.
: Activated when the trigger source changes from below the trigger level to above
the trigger level (rising).
: Activated when the trigger source changes from above the trigger level to below
the trigger level (falling).
Hold Off
See section 6.4.
6.9 Setting the Logic Trigger (SIMPLE)
To Next Page
Loading...
