6-24
IM 701240-01E
Setting the Bit Pattern/Status of Logic A and Logic B
(Only when using logic input channels)
11. Press the Logic Pattern soft key. The Logic Pattern setup dialog box appears.
12. Use jog shuttle+SELECT to select the pattern of each bit (Bit A1 to Bit A8 and
Bit B1 to Bit B8) of condition A from H, L, and X.
13. Like wise, use jog shuttle+SELECT to select the edge trigger OR status from
, , and –.
Setting the Trigger Level
14. Press the Select CH soft key. The channel selection menu appears.
15. Use jog shuttle+SELECT to set the channel to assign the trigger level.
16. Press the Level soft key.
17. Use jog shuttle+SELECT to set the trigger level.
18. Likewise, set the trigger level for all channels on which patterns were assigned
in steps 7 to 8.
Note
The trigger level setting applies to both simple and enhanced triggers.
Setting the Hysteresis
19. Press the Hysteresis soft key to select , , or .
Setting the Hold Off
20. Set the hold off time according to the procedures given in section 6.4.
Note
The pattern settings of conditions A apply to all trigger types.
6.12 Setting the Edge on A Trigger (ENHANCED)
To Next Page
Loading...
