6-28
IM 701240-01E
Setting the Status of Each Bit of Logic A and Logic B
(Only when using logic input channels)
9. Press the Logic Pattern soft key. The Logic Pattern setup dialog box appears.
10. Use jog shuttle+SELECT to select edge trigger OR status of each bit (Bit A1 to
Bit A8 and Bit B1 to Bit B8) from
, , and –.
Setting the Trigger Level
11. Press the Select CH soft key. The channel selection menu appears.
12. Use jog shuttle+SELECT to set the channel to assign the trigger level.
13. Press the Level soft key.
14. Use jog shuttle+SELECT to set the trigger level.
15. Likewise, set the trigger level for all channels on which patterns were assigned
in step 8.
Note
The trigger level setting applies to both simple and enhanced triggers.
Setting the Hysteresis
16. Press the Hysteresis soft key to select , , or .
Setting the Hold Off
17. Set the hold off time according to the procedures given in section 6.4.
6.13 Setting the OR Trigger (ENHANCED)
To Next Page
Loading...
