6-38
IM 701240-01E
Setting the Status of Each Bit of Logic A and Logic B
(Only when using logic input channels)
9. Press the Logic Pattern soft key. The Logic Pattern setup dialog box appears.
10. Use jog shuttle+SELECT to select the status of each bit (Bit A1 to Bit A8 and
Bit B1 to Bit B8) from
, , and –.
Selecting the Target Waveform
11. Press the Select CH soft key. The channel selection menu appears.
12. Use jog shuttle+SELECT to select the target channel.
Setting the Window (When the Target Waveform Is Not Logic)
Setting the Center Level
13. Press the Center/Width soft key to set the jog shuttle control to Center.
14. Turn the jog shuttle to set the center level.
Setting the Window Width
15. Press the Center/Width soft key to set the jog shuttle control to Width.
16. Turn the jog shuttle to set the window width.
Setting the Hysteresis
17. Press the Hysteresis soft key to select , , or .
Setting the Hold Off
18. Set the hold off time according to the procedures given in section 6.4.
6.16 Setting the Window Trigger (ENHANCED)
To Next Page
Loading...
