7-14
IM 701240-01E
Aborting Action-on-Stop
17. Press START/STOP. Waveform acquisition is stopped, and action-on-stop is
aborted.
Explanation
Mode
The specified record length of data is acquired when measurement is started, and the
waveform is displayed. Then, the specified action is executed. In addition, the specified
action is also executed when measurement is stopped. When action-on-stop is enabled,
the trigger mode is set to Log.
Action
The following five types of actions are available.
Print the Screen Image Data (PRINT)
Prints the screen image on the printer (Printer (built-in printer), USB (USB printer), or
Net Print (network printer)) specified by Print to in the PRINT menu.
Save the Screen Image Data (Image)
Saves the screen image data to the destination (PC card, internal HD (optional), SCSI
device, or USB storage device) specified in the IMAGE SAVE menu.
Save Waveform Data (Save to File)
Saves the waveform data in binary, ASCII, or floating format to the destination (PC
card, internal HD (optional), SCSI device, or USB storage device) specified in the
FILE menu. The save format is synchronized to data type (see section 13.8) on the
FILE menu.
Buzzer
Sounds a buzzer.
Send Mail
Sends an e-mail message to a specified address (when Ethernet interface option is
installed). Set the number of mail transmissions in the range of 1 to 1000.
For the procedure to set the address, see section 15.5.
Note
If action-on-stop is executed, the data is acquired in Log mode regardless of the trigger mode
setting, and the specified action is carried out. The specified action is also carried out when the
measurement is stopped in the middle of the measurement.
Sequence and ACQ Count
Sequence
Single: Performs the action once.
Continue: Performs the action the number of times specified by ACQ Count.
ACQ Count
2 to 65536: Repeats the action the specified number of counts.
Infinite: Repeats the action until waveform acquisition is stopped.
PRINT, Image, and Save to File Operations
Operates according to the settings in the PRINT, IMAGE, and FILE menus.
7.6 Setting the Action When Waveform Display Is Updated (Action-on-Stop)
To Next Page
Loading...
