8-4
IM 701240-01E
Number of Data Points Used for Waveform Display
When the area is not an interpolation area on the T-Y waveform display and Interpolation
is set to Sine or Line, the aforementioned P-P compressed values are displayed.
However, if Interpolation is set to OFF or if X-Y waveforms are being displayed, the
acquisition data is decimated, and data that has been picked up at certain intervals are
displayed. The number of data points used to display the waveform is 100 k.
If the record length is greater than or equal to 100 kW, the data is decimated to 100 kW,
and 100 points are displayed on a vertical line. Otherwise, all points are displayed.
If the number of data points per division is greater than or equal to 100 for a realtime
recorded waveform or when in roll mode, the maximum and minimum values at certain
number of data points of acquisition data are displayed using linear interpolation.
Data Interpolation and Envelope Mode
When the acquisition mode is envelope, the data is interpolated using an area regardless
of the specified interpolation method (see the following figure). This is because in
envelope mode the maximum and minimum values are determined over a certain
interval, and the data time position cannot be pinpointed.
True data
8.2 Setting the Display Interpolation Method
To Next Page
Loading...
