YOKOGAWA SL1400 - Page 259

8-7
IM 701240-01E
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
App
Index
Waveform Display and Information Display
Notes on Accumulation
• Automated measurement of waveform parameters is performed on the most recent
waveform.
• When printing accumulated waveforms using the built-in printer, they are printed using
two tones.
• If the waveform acquisition is forcibly stopped by pressing START/STOP, the
accumulation is temporarily suspended. When the acquisition is restarted, the display
is cleared and accumulation continues.
• You cannot change the parameters on the HISTORY menu when accumulating
waveforms on the display.
• Accumulated display is not possible in roll mode display.
• When you turn OFF the accumulate mode, accumulated waveforms are cleared. To
display the acquired waveforms again, specify the record number on the HISTORY
menu.
• If you display the waveforms again by setting the accumulate mode to Persist, the
accumulated waveforms are not cleared. To clear them, execute clear trace.
• Even if you change the display format during accumulated display, the waveforms that
are already displayed accumulated are not cleared. To clear them, execute clear
trace.
Clearing Accumulated Waveforms
You can clear accumulated waveforms by pressing CLEAR TRACE.
8.4 Accumulated Waveform Display