10-2
IM 701240-01E
Setting the Upper and Lower Limits of Waveform Display (When Scale Is
Set to Manual)
13. Use jog shuttle+SELECT to set the upper limit.
14. Likewise, set the lower limit.
Note
If you select Auto, you cannot set Upper and Lower.
Setting the Unit
15. Use jog shuttle+SELECT to set the Unit using up to four characters according
to the procedure given in section 4.2.
Setting the Label
16. Use jog shuttle+SELECT to set the Label according to the procedure given in
section 4.2. For a description of the label display, see section 8.10.
Turning ON/OFF the Math Waveform Display
17. Use jog shuttle+SELECT to turn the display ON or OFF.
As necessary, set Math2 to Math8 in a similar fashion.
18. Press ESC twice.
Executing the Computation
19. Press the Exec soft key.
ESC ESC
10.1 Adding, Subtracting, Multiplying, and Dividing Waveforms
To Next Page
Loading...
