10-11
IM 701240-01E
10
10
11
12
13
14
15
16
17
18
App
Index
Waveform Computation
10.4 Shifting the Phase
<For a description of this function, refer to page 2-42.>
Procedure
1. Press MENU.
2. Press the MATH soft key.
3. Press the Mode soft key to select ON.
Setting the Computation Start and End Points
4. Press the Start Point/End Point soft key to set the jog shuttle control to Start
Point.
5. Turn the jog shuttle to set the start point.
6. Likewise, set the End Point.
Setting the Computation
7. Press the Setup soft key. The Math1 to Math8 setup dialog boxes appear.
8. Use jog shuttle+SELECT to select the desired Math waveform. The
corresponding Math waveform setup dialog box appears.
Setting the Computing Operation
9. Use jog shuttle+SELECT to set Operation to Shift(S1).
Selecting the Channel on Which to Shift the Phase
10. Use jog shuttle+SELECT to select Source.
Setting the Scaling
11. Use jog shuttle+SELECT to set Scale to Auto or Manual.
If you select Manual, proceed to step 12; if you select Auto, proceed to step 14.
Setting the Upper and Lower Limits of Waveform Display (When Scale Is
Set to Manual)
12. Use jog shuttle+SELECT to set Upper.
13. Likewise, set Lower.
Note
If you select Auto, you cannot set Upper and Lower.
To Next Page
Loading...
