13-36
IM 701240-01E
Selecting the Destination Directory
(Perform this operation when directories are present on the medium.)
12. Turn the jog shuttle to select the save destination directory (indicated by < >).
13. Press SELECT to confirm the new directory. The selected medium/directory is
displayed in “Path=......” located above and to the left of the File List window.
Select <..> to move to the parent directory.
Setting the Name of the File to Be Saved
14. Press the File Name soft key. The file name setup menu appears.
15. Turn the jog shuttle to select Auto Naming.
16. Press SELECT to select OFF, Numbering, or Date.
17. Turn the jog shuttle to select File Name.
18. Enter the file name using up to 16 characters according to the procedure given
in section 4.2.
Note
• If Auto Naming is set to Numbering, the first four characters are valid. If Auto Naming is
set to Date, the file name is invalid.
• You can set up to 16 characters for the file name, but only 15 characters are displayed on
the setup menu.
Executing the Save Operation
19. Press IMAGE SAVE. The screen image data is saved to the storage medium.
Pressing IMAGE SAVE again aborts the save operation.
While the data is being saved, an icon corresponding the save destination
medium (
PC card, external SCSI device, internal HD, or USB
storage device) is displayed at the upper left corner of the screen.
Note
Thumbnails of the saved screen image data can be displayed. For details, see section 13.13.
13.12 Saving Screen Image Data
To Next Page
Loading...
