13-63
IM 701240-01E
Saving and Loading Data
13
Connecting the SL1400 and the PC
1. Turn OFF the SL1400 and the PC.
2. Connect the SL1400 and the PC with the SCSI cable.
3. Turn ON the SL1400 first.
4. After the SL1400 boots up completely, check that the connected SCSI device
operates on the SL1400.
5. Turn ON the PC.
SL1400
Precautions to Be Taken When Connecting
•Drive
When formatting the internal hard disk on the SL1400, the hard disk can be
partitioned into two or three drives. For example, your PC will identify the two
partitions on the SL1400 internal hard disk as drives F and G on the PC. The drive
with the smaller drive letter (drive F: in the above example) is the area dedicated to
the realtime recording. Other drives are used to store setup data, waveform data,
screen image data, etc.
The drive for realtime recording is used as a working area for the realtime
recording within the SL1400. Never delete files, copy and paste files, and add
new files on this drive from the PC. Otherwise, the realtime recording may not
operate properly.
Other drives are used to save other types of data such as waveforms that can be
recalled later. The waveforms that can be used on the PC are saved on this drive.
Newly Created File During Connection
If a file is created with the SL1400 while it is connected to the PC, the new file is not
recognized by the PC.
13.19 Connecting a PC to the SL1400 via SCSI
To Next Page
Loading...
