15-23
IM 701240-01E
Ethernet Interface (Option)
15
Preparations for Using the Web Server Function
Connecting the PC and the SL1400 to the Network
Connect the PC and the SL1400 to the network. For the connection procedure, see
section 15.1.
Preparations on the SL1400
Setting the Communication Interface to Network
Turn ON the power to the SL1400. After the SL1400 boots up normally, carry out the
following procedure.
1. Press MENU.
2. Press Next 1/2 soft key.
3. Press the Remote Cntl soft key. The Remote Cntl menu appears.
4. Press the Device soft key. The Device menu appears.
5. Press the Network soft key. The Ethernet interface is selected for the
communication means.
Setting up the TCP/IP
6. Set the TCP/IP on the PC and the SL1400. For the procedure on the SL1400,
see section 15.2.
Setting the User Account Used to Access the SL1400
7. Set the user account used to access the SL1400 from the PC. For the
procedure, see steps 1 to 9 in section 15.6.
Note
The User Account in the menu that appears after step 5 is the user account that is used to
control the SL1400 through communication commands via the Ethernet network. It is not the
user account for using the Web server function.
Setting the Time Difference from GMT (Greenwich Mean Time)
8. Set the time difference between the location where the SL1400 is located and
the GMT. For the procedure, see section 15.8.
Rebooting
9. To activate the TCP/IP, user account, and time difference settings, turn OFF the
power switch. After a few seconds, turn ON the power switch and boot the
SL1400.
15.7 Using the Web Server Function
To Next Page
Loading...
