15-33
IM 701240-01E
Ethernet Interface (Option)
15
• Selecting the Waveforms to Be Saved (File)
Selecting the Target Waveforms (Trace)
From the Trace box, select the waveforms to be saved from the following:
All (all waveforms), 1 to 16 (channels 1 to 16), Math 1 to Math 8 (computed
waveforms), and PodA to PodB (logic waveforms).
Selecting the Save Area (Range)
Select the area in which the target waveform to be saved is displayed from the
following:
Main, Z1, and Z2
For the meanings of the selections, see the explanation in section 13.8.
• Setting the History Data Display
Selecting by History Data Number (History No.)
You can specify the history number of the data to be displayed.
Selecting the Most Recent or Oldest Data
You can specify the most recent or the oldest data in the history data to be
displayed.
Selecting One or All
• One
Click One to display a single history data point that is selected by the data
number or selected by most recent or oldest.
• All
Click All to display all the history data.
• Updating the Setup Condition (Panel Update)
Click Panel Update to update the control panel settings on the Data Capture
window (PC) to match the most recent setup condition on the SL1400.
• Automatically Updating the Screen Image (Confirmation)
Select the Confirmation check box to automatically update the screen image using
the same conditions as Color-OFF when you change the settings of the above
items that would cause the screen image to change. Clear the check box to not
update automatically.
Note
• You cannot set the history data display when the SL1400 is making measurements.
• Setting the history data display when there is no history data results in error.
• The timeout time on the PC when controlling the SL1400 is 30 s. Depending on the
SL1400 condition, a timeout may occur preventing you from controlling the SL1400.
15.7 Using the Web Server Function
To Next Page
Loading...
