17-9
IM 701240-01E
17
Troubleshooting, Maintenance, and Inspection
Code Message and Corrective Action Section
1106 File system failure. Chapter 13
1107 File system failure. Chapter 13
1108 File system failure. Chapter 13
1109 Invalid media format. Chapter 13
1110 Cannot load this file format. Files stored on other models (DL/AG series) cannot be loaded. Chapter 13
1111 File is now being accessed. Execute after access is made. Chapter 13
1112 Cannot be executed while running. Press the START/STOP key to stop acquisition. 7.1
1113 Cannot find ‘.HDR’ file. Check the file. 13.8
1114 The specified file cannot be loaded on this ROM version or this model. Chapter 13
1115 No ch is displayed. Turn ON the display of the appropriate channel. 5.1
1116 Save data not found. Check for presence of data. Chapter 13
1118 SCSI controller failure. Maintenance service is required. –
1119 HDD overrun error. –
Due to spare sectors, the recording could not be finished within assigned time. The operation
is aborted.
1120 HDD error. An error occurred in the HDD. The operation is aborted. –
1121 Unknown file format. Check the file. Chapter 13
1124 Data that have been P-P compressed and saved cannot be loaded. 13.8
1126 Cannot save in this format at the current record length. Specify a range and save a section of the data.13.8
* Cannot create a file of size 2 GB or larger.
1127 Cannot load because the medium is selected. Select a setup file (SET). 13.9
1128 Cannot load because a directory is selected. Select a setup file (SET). 13.9
1129 Cannot load because the medium is selected. Select a binary file (.WVF). 13.8
1130 Cannot load because a directory is selected. Select a binary file (.WVF). 13.8
1131 Cannot load files larger than 50 MB on a network drive. 2.8, 13.17,
Copy the file to the local drive before loading it. 15.3
1132 Cannot load a HistoryAll binary file on a network drive. 13.8
1133 Turn the HDD motor ON. 13.3
1134 If the realtime recorded file is converted to binary format, the converted file cannot be loaded. 13.15
1135 Cannot save the waveform by specifying Z1 (Z2) for the range to be saved, if the zoom rate is 13.8
set to x1.
Save the waveform by specifying Main for the range to be saved.
1137 Cannot make a directory or a file in the real-time area of the internal hard disk. 7.5, 13.15,
Change the current directory. 13.17
1138 Cannot save at the current PDF setting. 9.8, 13.14
Change the settings.
* A file of size exceeding 2 GB cannot be created.
1139 Cannot create PDF files on the network drive when the history waveform display format is set to All. –
Create the file on the local drive, and then copy it to the network drive.
1140 Cannot save files with Japanese file names to the network drive. 4.2
1141 Cannot copy files with Japanese file names to the network drive. 4.2
1142 Cannot create a PDF file with a Japanese file name if the Japanese font is OFF. 9.8, 13.14
1143 The setup data is not saved. 13.1
17.2 Messages and Corrective Actions
To Next Page
Loading...
