H: Upgrade Kit Instructions
Mag Encoder
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 239
Mag Encoder
Upgrade Kit Instructions
Introduction
These instructions describe installing Mag Encoder Upgrade Kit P1031925-075 in a Zebra
ZXP Series 3 Card Printer.
In general, only removal directions are presented; unless otherwise noted, replacement would
be performed by reversing the removal steps.
Caution • This kit may only be installed by Zebra trained and certified personnel.
Any attempt to install it by other than Zebra trained and certified personnel will
void the product warranty and may cause damage to the equipment.
To Next Page
Loading...
