240 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
H: Upgrade Kit Instructions
Mag Encoder
Parts List
Special Tools
• Flat-blade Screwdrivers, from 1/16 inch (1.5 mm) to 1/4 inch (6.5 mm)
• Phillips Screwdrivers: numbers 0, 1, and 2
•
TORX T8 and TORX T10 drivers
• Fine-Point, Offset Fine-Point, and Needle-Nose pliers
• Small Diagonal Cutters or other cutter for cutting cable ties
• Hex Wrench, 1/16 inch head
• Hex Socket, 5.5 mm (this can also be used for securing push nuts)
• Small and Medium Spring Hook Tools
•
LOCTITE
®
420 or equivalent
• Gear Puller
• E-Ring Fastener Tool
• Belt Tensioning Tool, Zebra P/N 900754-003
Procedure
Upgrade Kit: P1031925-075; KIT, UPGRADE, MAG ENCODER, ZXP3
QTY PART NUMBER DESCRIPTION
1 P1029580-004 KIT,MAG,ZXP3 R2
4 806822-001 FOOT,CYLINDRICAL,ADH-BACKED
Electric Shock Caution • Before performing any of the procedures in this section, set
the printer power to OFF (O) and disconnect the power cord.
Electrostatic Discharge Caution • This replacement procedure must be performed at a
static-free work station, an anti-static wrist strap must be worn and properly terminated,
or other appropriate protection must be used.
Caution • Before beginning any of the steps that follow, read completely through this
procedure. If you do not have the specified tools, or if any step(s) seem beyond your skill
or experience level, do not attempt the procedure. You may cause additional damage to
the printer.
To Next Page
Loading...
