Zebra ZXP Series 3 - Page 247

H: Upgrade Kit Instructions
Mag Encoder
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 241
Preliminary Steps
Do the following:
a. Remove the Left Side Cover (Page 242)
b. Remove the Right Side Cover (Page 243)
c. Remove the Bottom Cover (Page 244)
d. Remove the Rear Cover (Page 245)
e. Remove the Main PCBA (Page 246)
f. Remove the Right Side Linkage (Page 249)
g. Remove the Right Side Rocker (Page 250)
h. Remove the Printhead Lift Motor (Page 252)
i. Remove the Left Side Linkage (Page 253)
j. Remove the Stepper Motor (Page 254)
k. Remove the Left Side Rocker (Page 256)
l. Remove the Platen Roller (Page 258)