294 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
H: Upgrade Kit Instructions
Manual Card Feed Module Upgrade Kit Instructions
Special Tools
• TORX T10 Driver
• Flat-blade Screwdriver
• 5.5mm Nut Driver
• Small Diagonal Cutters or other cutter for cutting cable ties
Procedure
Preliminary Steps
Do the following:
a. Remove the Left Side Cover (Page 114)
b. Remove the Right Side Cover (Page 115)
c. Remove the Bottom Cover (Page 126)
d. Remove the Front Bezel (Page 142)
Electric Shock Caution • Before performing any of the procedures in this section, set
the printer power to OFF (O) and disconnect the power cord.
Electrostatic Discharge Caution • This replacement procedure must be performed at a
static-free work station, an anti-static wrist strap must be worn and properly terminated,
or other appropriate protection must be used.
Caution • Before beginning any of the steps that follow, read completely through this
procedure. If you do not have the specified tools, or if any step(s) seem beyond your skill
or experience level, do not attempt the procedure. You may cause additional damage to
the printer.
To Next Page
Loading...
