H: Upgrade Kit Instructions
Printhead
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 301
Removal
Step 1. Turn the printer off, and disconnect the power cord.
Step 2. Press the Lid Release Button, and raise the Lid.
Step 3. Locate the Printhead (circled above).
Important • This procedure describes replacing the Printhead. The Printhead is supplied
with components in correct alignment with each other. These alignments are critical to proper
operation of the printer. Do not deviate from the procedure given here, do not loosen or
tighten any screws except those specifically noted in this procedure, and do not attempt to
adjust any part of the Printhead.
NOTE • The Printhead can be replaced without removing any other parts of the printer.
To Next Page
Loading...
