Zebra ZXP Series 3 - Page 306

300 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
H: Upgrade Kit Instructions
Printhead
Special Tools
• Flat-blade Screwdriver
Procedure
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 301
Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 304
Tests and Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 305
Electric Shock Caution • Before performing any of the procedures in this section, set
the printer power to OFF (O) and disconnect the power cord.
Electrostatic Discharge Caution • This replacement procedure must be performed at a
static-free work station, an anti-static wrist strap must be worn and properly terminated,
or other appropriate protection must be used.
Caution • Before beginning any of the steps that follow, read completely through this
procedure. If you do not have the specified tools, or if any step(s) seem beyond your skill
or experience level, do not attempt the procedure. You may cause additional damage to
the printer.