Zebra ZXP Series 3 - Page 305

H: Upgrade Kit Instructions
Printhead
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 299
Printhead
Spare Kit Instructions
Introduction
These instructions describe installing Printhead Spare Kit in a Zebra ZXP Series 3 Card
Printer. Refer to Appendix M for ordering the correct printhead kit.
For this procedure, a YMCKO Ribbon is required
Driver Version 2.02.00.00 or higher is required, and Firmware Version 1.04.00 or higher
should be installed in the Printer.
In general, only removal directions are presented; unless otherwise noted, replacement
would be performed by reversing the removal steps.
Caution • This kit may only be installed by Zebra trained and certified personnel.
Any attempt to install it by other than Zebra trained and certified personnel will
void the product warranty and may cause damage to the equipment.