Zebra ZXP Series 3 - Page 312

306 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
H: Upgrade Kit Instructions
Printhead
Preliminary Setup - Printer properties
Step 1. Go to Start > Devices and Printers. Right click on the Zebra ZXP Card Printer
listing, then select Printer properties.
Step 2. Click on Device Settings > Tools.
Step 3. This brings up the Tools window.
Step 4. From the Tools window, perform the following tests and adjustments:
Printhead Resistance Update . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 307
Ribbon Sensor Calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 307
Monochrome Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 308
Type the
command
here...
... then
click the
Execute
button.