310 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
H: Upgrade Kit Instructions
MIFARE & Contact
Parts List
Special Tools
• TORX T10 Driver
• Flat-blade Screwdriver
• 5.5mm Nut Driver
• Small Diagonal Cutters or other cutter for cutting cable ties
Procedure
Upgrade Kit: P1031925-204; KIT, UPGRADE, MIFARE & CONTACT
QTY PART NUMBER DESCRIPTION
1 P1027093-003 KIT,ENCDR,MIFR,ZXP3,R2
4 806597G-404 SCR,PH,TORX,PLAST,4-.25L,ZN
1 P1027713 CARD CATCHER BASE, ZXP3
1 P1027714 CARD CATCHER BASKET,ZXP3
4 806822-001 FOOT,CYLINDRICAL,ADH-BACKED
1 806597G-406 SCR,PH,TORX,PLAST,6-.25L,ZN
1 P1026176-002 ENCLOSURE,FRONT,ENCODE,ZXP3 R2.0
Electric Shock Caution • Before performing any of the procedures in this section, set
the printer power to OFF (O) and disconnect the power cord.
Electrostatic Discharge Caution • This replacement procedure must be performed at a
static-free work station, an anti-static wrist strap must be worn and properly terminated,
or other appropriate protection must be used.
Caution • Before beginning any of the steps that follow, read completely through this
procedure. If you do not have the specified tools, or if any step(s) seem beyond your skill
or experience level, do not attempt the procedure. You may cause additional damage to
the printer.
To Next Page
Loading...
