4: Troubleshooting
Troubleshooting Procedures
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 91
Note: If the problem persists, contact Technical Support; see Appendix M.
OUT OF RIBBON Check ribbon. May be defective or
entirely used.
Load a new ribbon cartridge. Refer to
Installing the Ribbon Cartridge on
page 66.
PARAMETERS ERROR A parameter error occurred. Reset the Printer, and try printing the
card again.
ERROR MESSAGES (printer will not operate)
Problem / Symptom Description or Cause Possible Solution
Note
To Next Page
Loading...
