Accu-Chek Inform II

164
08424705001 (01) 2017-04 USA • Accu-Chek Inform II Operator’s Manual Version 6
Automatic power-off
The meter powers off after a configurable time without
activity (e.g., pressing a key, touching the screen) and goes
into standby mode to save power. In addition, the meter
may power off automatically for the reasons listed below.
Reactivate the meter/screen as described in the following:
Power-off after time specified by
system administrator (default is
5 minutes, configurable by system
administrator)
– Press the On/Off button on the meter.
Battery Low – Charge the battery by placing the meter in the base unit.
Battery Critically Low – Charge the battery by placing the meter in the base unit.
– Check that the battery pack is correctly installed and
connected.
– Replace the defective battery pack.
Follow the instructions in Chapter 9 to avoid data loss when
replacing the battery pack.
Display/symptom Possible solution