Aeroflex 3901 - Page 133

AutoTest Sytem Operation
Subject to Export Control, see Cover Page for details.
5-37
Config Commands (cont)
set_tribpower_ulimit [ limit dBm ]
Sets TR inband power meter upper limit.
Format: Decimal limit value in dBm
set_tribpower_ulen [ state 0/1 ]
Enables/Disables the upper limit check on TR inband power meter.
Valid states are:
0 = Disabled
1 = Enabled
set_tribpower_llimit [ limit dBm]
Sets TR inband power meter lower limit.
Format: Decimal limit value in dBm
set_tribpower_llen [ state 0/1 ]
Enables /Disables the lower limit check on TR inband power meter.
Valid states are:
0 = Disabled
1 = Enabled
set_tribpower_average
Sets number of averages used to calculate measurement.
Format: Whole number
Range: 1 to 250
set_antibpower_average
Sets number of averages used to calculate measurement.
Format: Whole number
Range: 1 to 250
set_antibpower_ulimit [ limit dBm ]
Sets ANT inband power meter upper limit.
Format: Decimal limit value in dBm
set_antibpower_ulen [ state 0/1 ]
Enables/Disables the upper limit check on ANT inband power meter.
Valid states are:
0 = Disabled
1 = Enabled
set_antibpower_llimit [ limit dBm ]
Sets ANT inband power meter lower limit.
Format: Decimal limit value in dBm
set_antibpower_llen [ state 0/1 ]
Enables /Disables the lower limit check on ANT inband power meter.
Valid states are:
0 = Disabled
1 = Enabled