Shipping Test Set
Subject to Export Control, see Cover Page for details.
A-2
Repacking Procedure
1. Make sure bottom packing mold is seated on floor of shipping container.
2. Adjust handle to lay unlocked against Test Set as shown.
3. Place Elastic Retainer around Test Set to secure handle.
4. Carefully wrap Test Set with polyethylene sheeting.
5. Place Test Set into shipping container, making sure Test Set is securely seated in bottom
packing mold.
6. Place top packing mold over top of Test Set and press down until mold rests solidly on bottom
packing mold.
7. Close shipping container lids and seal with shipping tape or an industrial stapler. Tie all sides of
container with break resistant rope, twine or equivalent.
Fig. A-1 Repacking Procedure
To Next Page
Loading...
