Aeroflex 3901 - Page 5

Subject to Export Control, see Cover Page for details.
iii
Service Upon Receipt of Material
Unpacking
Special design packing material inside the shipping container provide maximum protection for the
Test Set. Avoid damaging the shipping container and packing material when unpacking equipment;
if necessary the shipping container and packing material can be reused to ship the Test Set.
To prevent personal injury or damage to the Test Set, Aeroflex recommends two people unpack
the Test Set.
Use the following steps to unpack the Test Set:
STEP PROCEDURE
1. Cut and remove sealing tape on top of the shipping container. Open shipping container and
remove top packing mold.
2. Grasp Test Set firmly while restraining the shipping container. Lift the equipment and packing
material vertically out of the shipping container.
3. Place Test Set and end cap packing on a flat, clean and dry surface.
4. Remove protective plastic bag from the Test Set.
5. Place protective plastic bag and end cap packing materials inside shipping container.
6. Store shipping container for possible future use.
Repacking Procedure