Test Set Operation
Subject to Export Control, see Cover Page for details.
3-44
[Networking] Soft Key
Enables/Disables network access. When Enabled, the Test Set can be configured to be
accessed from a remote location.
[DHCP] Soft Key
Selects manner in which the network access is configured. Typical configurations are as follows:
Static Configuration (DHCP OFF)
If Static configuration is selected:
1. Configure IP, subnet mask, Gateway and DNS values.
2. Choose whether the Test Set is to be configured on boot up or upon user request.
3. Select Validate Configuration.
4. The Test Set then queries on the network for a DHCP server and updates the IP, subnet
mask, Gateway and DNS (Domain Name Server) fields upon completion of the transaction
with the server.
Automatic Configuration (DHCP ON)
If Automatic configuration is selected:
1. Choose whether the Test Set is to be configured on BOOT UP or upon USER request.
2. Select Validate Configuration.
3. The Test Set then queries on the network for a DHCP server and updates the IP, subnet
mask, Gateway and DNS (Domain Name Server) fields upon completion of the transaction
with the server.
[Validate Changes] Soft Key
Accepts current network configuration and re-establishes (restarts) network operation.
[NTP Client] Soft Key
Network Time Protocol Client allows the Test Set to be synchronized with an external time
server.
[Sync NTP] Soft Key
Synchronizes the Test Set with an external time server. [NTP Client] Soft Key must be Enabled
before pressing this soft key.
To Next Page
Loading...
