242 1100 Series Nano Pump Service Manual
6 Control Module Screens for the Nano Pump
Status This is an example if an Agilent 1100 pump is configured standalone.
Information on the actual flow rate, mobile phase composition, pressure and
%-Ripple, elapsed run time and the pressure plot are shown. Press key F8
(Start) to start a run, key F7 (Rescale) to maximize the signal.
Signal plot Press F6-key (Plot) to enter the plot screen (available also from all other
views). Here you can observe online signal(s). If more than one signal is
configured, use the 1-2-3 numeric keys to switch between the signals.
To Next Page
Loading...
