Introduction
6850
6850
Released: April 2004 6850 Series Gas Chromatograph Service Procedures 8
Tools and test equipment
Table 1-1. Tools required
1/2-inch adjustable wrench
1/2-inch x 7/16-inch open end wrench
1/8-inch allen wrench
3/16-inch wrench
3-mm allen wrench for actuator
5/16-inch x 1/4-inch open end wrench
7/16-inch wrench x 3/8-inch open end wrench
9/16-inch x 5/8-inch open end wrench
9/16-inch x 7/16-inch open end wrench
Flat blade screwdriver
1/4-inch hex nut driver
7-mm hex nut driver
No. 1 Posidriv screwdriver
No. 2 Posidriv screwdriver, 4-inch shaft
T-10 and T-20 Torx drivers
Inlet wrench
Column cutter
Blanking plug, finger-tight style
ESD protective wrist strap
Ferrule, no hole or plug
FID flow measuring insert
MPC plumbing kit
Plug, 1/8-inch brass (6-pack)
Pneumatic LK test kit
Tube, assembly tool PTFE
Tweezers
Volt/Ohm meter
Flow Tracker 1000 Flowmeter
Handheld electronic leak detector, 110 V
Handheld electronic leak detector, 220 V
Agilent GC Firmware Update Utility or greater
To Next Page
Loading...
