24 ChemStation Workflow
3 Data Analysis
Data Analysis: Data Review
The remainder of this section specifies which method is loaded during
data review when a run is loaded from the navigation table. They only
apply to data review, but not to reprocessing. The following separate
option sets are available for sequence runs and single runs:
Keep “Current Method”
The review setting Current Method should always be used when you want to
use the method that is currently loaded. In this respect, for data review
the current method remains irrespective of which single run data file or
sequence container file is loaded. You can enable this option by selecting
Current Method in the Preferences dialog, see Figure 11 on page 25. This
ensures that, for each run loaded, the same method is always kept in
memory.
Table 1 Data Review Options for Sequence and Single Run Data
Method used for review of sequence data Method used for review of single run data
Current Method Current Method
Sequence Method Individual method from data file (DA.M)
Individual method from data file (DA.M)
NOTE
The options on the Signal/Review Options tab of the Preferences dialog are only applied
when loading a data file from the Navigation Table. When using Load Signal from the File
menu or the corresponding icon in the main tool bar, the settings are not applied, e.g. no
method is loaded.
To Next Page
Loading...
Need help?
General
