26 ChemStation Workflow
3 Data Analysis
Data Analysis: Data Review
Load “Sequence Method”
When you review the data using the option Sequence Method (see Figure 12
on page 26), each time you load a run from the Navigation Table, the
sequence method corresponding to the run's sequence line is loaded. As
the name of this option implies, it is only available for review of sequence
data sets, but not of single runs.
Figure 12 Load the Sequence Method for Data Review
A typical application for this option is sequence- specific optimization of
data analysis parameters, especially as preparation for reprocessing (see
“Data Analysis: Reprocessing Data” on page 32). Once every run has been
reviewed and the sequence methods have been improved, the complete
sequence can be reprocessed with the updated methods.
It may be necessary to propagate the changes in the sequence method to
the corresponding master method as input for all future acquisition runs.
You can achieve this conveniently by e.g. using the Update Master Method
functionality (see Table 3 on page 31).
To Next Page
Loading...
Need help?
General
