Amazone AMATRON 3 - Starting GPS Switch Without Job Management

11.3.2 Starting GPS switch without job management
REQUIREMENTS
If GPS switch should be started without job
management, the following requirements must
be met:
GPS is configured; see page
For ISOBUS implements and AMABUS
implements: Implement is connected
For ISOBUS implements: ISOBUS is
configured, see page 24
For AMABUS implements and implements that
cannot communicate with the terminal:
Implement is selected, see page 45
The tractor is selected, see page 52
Job management is disabled, see page 19
Select Main menu > "GPS switch".
GPS switch will be started.
The following contents are shown on the GPS
switch map.
A tractor symbol
An implement symbol
CMS-I-002167
CMS-T-005152-A.1
11 | Using the GPS switch
Starting the GPS switch
MG5560-EN-II | E.1 | 21.04.2020
94