7.2
Configuring ISOBUS
REQUIREMENTS
The ISOBUS can only be configured in
ISOBUS mode, see page 15
1. Select "Setup" > "Settings" > "ISOBUS".
The AMATRON 3 has a clear identification number
for the Universal Terminal, the ISOBUS-UT number. If
the implement controls should be displayed on the
AMATRON 3, the ISOBUS-UT number must match
with the ISOBUS-UT number of the implement. If the
AMATRON 3 is the only connected terminal, the
implement automatically adopts the ISOBUS-UT
number of the AMATRON 3.
2. Under "ISOBUS-UT number", enter the
identification number for the Universal Terminal of
the AMATRON 3.
For job documentation, the AMATRON 3 has a clear
identification number, the Task Controller ID. If the job
documentation should be saved on the AMATRON 3,
the Task Controller ID must match with the Task
Controller ID of the implement. If the AMATRON 3 is
the only connected terminal, the implement
automatically adopts the Task Controller ID of the
AMATRON 3.
3. Under "Task Controller ID", enter the identification
number for the Task Controller of the AMATRON
3.
If the connected tractor does not send any geometry
or sensor data or if the tractor data should not be
used, the AMATRON 3 can simulate a tractor. The
AMATRON 3 has a clear identification number for the
simulated tractor, the TC-ID TECU. To be able to use
the simulated TECU, the TECU-ID must match with
the Task Controller ID.
4. Under "TC-ID TECU", enter the identification
number for the simulated Tractor-ECU.
CMS-T-001933-A.1
7 | AMATRON 3 configuration
Configuring ISOBUS
MG5560-EN-II | E.1 | 21.04.2020
24
To Next Page
Loading...
Need help?
General
