9.4
Configuring the tractor sensors
The tractor sensor must only be configured if the
tractor does not have any speed sensors and
therefore does not send speed data. In the case, the
speed data can be transmitted to the AMATRON 3 by
external sensors, e.g. wheel sensors or GPS sensors.
REQUIREMENTS
The AMATRON 3 is started in ISOBUS mode,
see page 15
1. "Tractor data" > "Sensors".
The "Sensors" menu will be opened.
CMS-I-002229
2. Under "Speed source", enter the device used to
determine the tractor speed.
NOTE
Only speed sources that are not yet signed in to
the ISOBUS are shown.
3. Under "PTO shaft", enter the number of pulses
sent by the PTO shaft with each rotation.
4. If the wheel sensor or radar sensor was selected
under "Speed source",
enter the number of pulses sent by the wheel
sensor or radar sensor over a distance of 100 m
under "Pulses per 100 m"
or
If the number of pulses per 100 m is not known,
Select "Count pulses over 100 m" and follow the
instructions on the screen.
CMS-I-001267
CMS-T-002594-B.1
9 | Configuring tractors
Configuring the tractor sensors
MG5560-EN-II | E.1 | 21.04.2020
51
To Next Page
Loading...
Need help?
General
