Amazone AMATRON 3 - Using Part-Width Section Control; Using Manual Part-Width Section Control

11.12.5.3 Creating A+ lines
REQUIREMENTS
"A+" track line pattern is selected; see
page 103
1. Drive to the beginning of the row.
2. select .
The number area for entering the track line angle
will be opened.
NOTE
The preset angle for the track line corresponds to
the vehicle orientation relative to the north-south
axis. If the preset angle is used, the track line are
oriented in the direction of travel.
3. If the track lines should not be oriented in the
direction of travel,
enter the desired angle for the track lines and
confirm.
11.13
Using part-width section control
11.13.1
Using manual part-width section control
11.13.1.1
Activating manual part-width section control
GPS switch can also be operated manually, in this
case, the automatic part-width section control is
disabled. The part-width sections must be switched
on and off manually.
CMS-T-005577-A.1
CMS-T-00004691-A.1
CMS-T-00004692-A.1
CMS-T-006306-B.1
11 | Using the GPS switch
Using part-width section control
MG5560-EN-II | E.1 | 21.04.2020
109