Amazone AMATRON 3 - Editing Tractor Geometry

2. Enter a name for the tractor under "Name".
CMS-I-001277
9.3
Editing the tractor geometry data
The implement geometry data is required for the GPS
switch to function properly. The part-width section
control, track guidance and variable rate control
depend on the correct geometry.
The geometry data must be entered in the
following cases:
The tractor does not send any geometry data.
The geometry data sent by the tractor should not
be used.
The GPS receiver was installed on the tractor
retroactively.
1. "Tractor data" > "Geometry data".
CMS-I-001580
CMS-T-002589-B.1
9 | Configuring tractors
Editing the tractor geometry data
MG5560-EN-II | E.1 | 21.04.2020
49