EasyManuals Logo

Amazone AMATRON 3 User Manual

Amazone AMATRON 3
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
Configuring tractors
9
9.1
Managing tractors
For the AMATRON 3 to be able to control the
connected implement properly, the data for the
utilised tractor must be transmitted to the AMATRON
3.
The following tractor data is required:
Geometry data
Sensor data
NOTE
ISOBUS tractors can automatically transmit their
data to the AMATRON 3. The ISOBUS tractor
must be configured accordingly. More information
on this topic can be found in the ISOBUS tractor
operating manual.
NOTE
A tractor must be configured in the following
cases:
The AMATRON 3 is operated in AMABUS
mode
Data transmission of the ISOBUS tractor is
disabled
The data sent by the ISOBUS tractor should
not be used
CMS-T-00004676-A.1
CMS-T-001903-B.1
9 | Configuring tractors
MG5560-EN-II | E.1 | 21.04.2020
47

Table of Contents

Other manuals for Amazone AMATRON 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Amazone AMATRON 3 and is the answer not in the manual?

Amazone AMATRON 3 Specifications

General IconGeneral
BrandAmazone
ModelAMATRON 3
CategoryTouch terminals
LanguageEnglish

Related product manuals