Amazone AMATRON 3 - Determining the Correction Times for On;Off Point Delays

11.2.10 Determining the correction times for on/off point delays
Length of the overlap (A) / Length of the unworked area (B)
0.5 m 1.0 m 1.5 m 2.0 m 2.5 m 3.0 m
Forward speed [km/h]
5 360 ms 720 ms 1080 ms 1440 ms 1800 ms 2160 ms
6 300 ms 600 ms 900 ms 1200 ms 1500 ms 1800 ms
7 257 ms 514 ms 771 ms 1029 ms 1286 ms 1543 ms
8 225 ms 450 ms 675 ms 900 ms 1125 ms 1350 ms
9 200 ms 400 ms 600 ms 800 ms 1000 ms 1200 ms
10 180 ms 360 ms 540 ms 720 ms 900 ms 1080 ms
11 164 ms 327 ms 491 ms 655 ms 818 ms 982 ms
12 150 ms 300 ms 450 ms 600 ms 750 ms 900 ms
13 138 ms 277 ms 415 ms 554 ms 692 ms 831 ms
14 129 ms 257 ms 386 ms 514 ms 643 ms 771 ms
15 120 ms 240 ms 360 ms 480 ms 600 ms 720 ms
Correction times for speeds and distances (A, B) that
are not listed can be interpolated, extrapolated or
calculated using the following formula:
CMS-I-002149
The on/off point delay for seeding technology for
switching on and off is influenced by the
following factors:
Delivery times depending on the seed type,
conveyor section and the blower fan speed
Driving behaviour depending on the forward
speed, acceleration and braking
GPS accuracy depending on the correction signal
and update rate of the GPS receiver
NOTE
For precise switching at the headlands –
especially for seed drills – the following points
are absolutely necessary:
RTK accuracy of the GPS receiver (update
rate min. 5 Hz)
Constant speed when driving in or out of the
headlands
CMS-T-006363-C.1
11 | Using the GPS switch
Entering the basic settings for GPS switch
MG5560-EN-II | E.1 | 21.04.2020
90