Amazone AMATRON 3 - Entering the GPS Switch Settings for Spreaders

11.2.6 Entering the GPS switch settings for spreaders
11.2.6.1 Automatically creating a safety zone
This function defines whether a safety zone is
automatically created inside a field boundary.
REQUIREMENTS
For AMABUS spreaders:
Spreader is connected
The AMATRON 3 is started in AMABUS mode,
see page 15
Spreader is selected in the implement menu,
see page 45
For ISOBUS spreaders:
Spreader is connected
The AMATRON 3 is started in ISOBUS mode,
see page 15
Select "GPS switch" > > "Automatically
create safety zone".
Possible settings:
: When a field boundary is created, a safety
zone is automatically created.
: When a field boundary is created, a query is
shown as to whether a safety zone should be
created.
CMS-I-002113
CMS-T-00004681-A.1
CMS-T-006129-A.1
11 | Using the GPS switch
Entering the basic settings for GPS switch
MG5560-EN-II | E.1 | 21.04.2020
82