TABLE OF CONTENTS
1 About this operating manual 1
1.1 Other applicable documents 1
1.2 Validity 1
1.3 Diagrams
1
1.3.1 Notes 1
1.3.2 Instructions 2
1.3.3 Lists 3
1.3.4 Item numbers 3
1.3.5 Orientation paths 4
2 Installation instructions 5
2.1 Basic installation 5
2.2 Mounting for ISOBUS mode 6
2.3 Mounting for AMABUS mode 7
2.4 Mounting for parallel operation
8
3
AMATRON 3 overview
9
3.1 Front side
9
3.2 Rear side 10
4
Basic operation
11
4.1 Using the toggle button
11
4.2 Using the F keys 12
4.3 Using the directional pad
12
4.4 Entering text 12
4.5 Entering numerical values 13
4.6 Using the shift key
14
5
After switching on
15
5.1 Selecting the BUS mode 15
5.2 Checking the AUX-N assignments 16
5.3 Changing the AUX-N assignments 17
6 Main menu overview
18
7 AMATRON 3 configuration 19
7.1 Entering the basic settings 19
7.1.1 Enabling or disabling job
management 19
7.1.2 Enabling or disabling ignition
switching 19
7.1.3 Adjusting the volume 20
7.1.4 Setting the brightness
21
7.1.5 Setting the date and time 22
7.1.6 Setting the region and language 23
7.2 Configuring ISOBUS 24
7.3 GPS configuration 25
7.3.1 Setting up the A100/A101 receiver 25
7.3.2 Setting up the AG-STAR receiver 25
7.3.3 Setting up the SMART6 receiver 27
7.3.4 Setting up other GPS receivers 28
7.4 Setting up the ASD interface 28
7.5 Adjusting the light bar
29
7.6 Configuring the toggle button 29
7.7 Defining the start mode 30
7.8 Configuring parallel operation
30
7.9 Using AUX-N input devices 31
7.9.1 Defining the AUX-N assignment 31
7.9.2 Defining the AUX-N assignment
using the functions list
34
7.9.3 Defining the AUX-N assignment
using the input list 35
7.9.4 Deleting the selected AUX-N
assignment
36
7.9.5 Deleting all AUX-N assignments 37
7.10 Using the licence management
37
7.11 Using the diagnostics 39
7.11.1 Using USB management 39
7.11.2 Using the pool management
40
7.11.3 Using the CAN diagnosis 40
MG5560-EN-II | E.1 | 21.04.2020
I
To Next Page
Loading...
Need help?
General
