Amazone AMATRON 3 User Manual

7.11.4 Performing a reset 41
8 Configuring implements 42
8.1 Managing implements 42
8.2 Editing the implement data
43
8.3 Editing the implement geometry
data 44
8.4 Selecting the implement 45
9 Configuring tractors 47
9.1 Managing tractors 47
9.2 Editing the tractor data
48
9.3 Editing the tractor geometry data 49
9.4 Configuring the tractor sensors 51
9.5 Selecting the tractor
52
10
Using the job management
53
10.1 Managing jobs 53
10.2 Editing jobs 55
10.2.1 Creating a new job 55
10.2.2 Adding setpoints to a job
55
10.2.3 Adding a worker to a job 58
10.2.4 Adding implements and tractors to
a job
60
10.2.5 Checking the map type 62
10.2.6 Searching for jobs 63
10.2.7 Copying jobs
63
10.2.8 Starting a job 64
10.2.9 Stopping a job
65
10.2.10 Exporting jobs 65
10.3 Using master data management
66
10.3.1 Managing master data 66
10.3.2 Managing setpoints 67
10.3.3 Editing the setpoints
68
10.3.4 Managing fields 69
10.3.5 Editing the field data
70
10.3.6 Managing the customers 70
10.3.7 Editing the customer data 71
10.3.8 Managing workers
71
10.3.9 Editing worker data 72
10.3.10 Managing products
72
10.3.11 Editing the product data 73
11 Using the GPS switch 74
11.1 GPS switch overview 74
11.1.1 GPS switch interface
74
11.1.2 GPS switch functions 77
11.1.3 GPS quality requirements 79
11.2 Entering the basic settings for
GPS switch 79
11.2.1 Defining the implement modelling 79
11.2.2 Select the source for the driving
direction detection 80
11.2.3 Enabling the acoustic field
boundary warning 80
11.2.4 Defining the map display 81
11.2.5 Defining the map alignment 81
11.2.6 Entering the GPS switch settings
for spreaders 82
11.2.7 Entering the GPS switch settings
for sprayers 84
11.2.8 Entering the GPS switch settings
for seed drills
85
11.2.9 Setting the on/off point delays 87
11.2.10 Determining the correction times for
on/off point delays 90
11.2.11 Checking the switch-on and -off
times
91
11.3 Starting the GPS switch 92
11.3.1 Starting GPS switch with job
management
92
11.3.2 Starting GPS switch without job
management 94
11.4 Zooming the map 95
11.5 Panning the map
96
11.6 Turning around the orientation of
the tractor symbol 96
11.7 Marking obstacles 97
11.8 Deleting an obstacle marking
98
11.9 Creating the field boundary 98
11.10 Deleting the field boundary 99
11.11 Managing virtual headlands
100
11.11.1 Creating virtual headlands 100
11.11.2 Locking or unlocking the headlands
102
TABLE OF CONTENTS
MG5560-EN-II | E.1 | 21.04.2020
II

Amazone AMATRON 3 Specifications

General

Brand	Amazone
Model	AMATRON 3
Category	Touch terminals
Language	English